L1 and L2 are the terminals on a light switch. Ground wire runs together with the live wire originating from the switch, meaning one end connects to the bulb and the other to the switch's pin. The switch, when turned on, allows the conductivity by joining the live wire within itself with the help of a thin metal sheet (sealed inside the switch). The live wire on a switch carries the current that originates from the main power supply, and goes through the switch before reaching the bulb. The source of a neutral wire is the main power supply, running directly to the bulb (it does not go through the light switch). Instead, the wire runs through a connector block and then reaches the bulb. The ground wire carries excess current to the ground to avoid electrical hazards.Ī neutral wire on a switch is not necessarily connected directly to the bulb. The live wire carries the electricity, while the neutral wire is meant to complete the circuit to ensure the flow of electricity. The three wires on a switch are live, neutral, and ground.

In New South Wales, you will need to hire a professional electrician. In Western Australia, the government asks every licensed electrician to provide an electrical safety certificate to the clients within 28 days. The South Australian State Government urges people to hold an SA trade licence, training, and a certificate of compliance.According to Energy Safe Victoria, changing light switches on a site is marked illegal, inviting up to $5,000 penal charges for individuals.Tasmania is governed by Service and Installation Rules and Occupational Licensing Act 2005, restricting unqualified personnel to carry out electrical wiring work. Performing an electrical task exposing a person to a risk of death or serious injuries attracts fines up to $600,000 (if an individual) or $3,000,000 (if a corporation) in addition to five years of imprisonment. Violating the rules will attract fines up to $22,000.Īccording to Worksafe Queensland, any DIY electrical job (wiring and or rewiring a light switch) is illegal, inviting penalties of up to $40,000. Merely supervising another person also needs a permit according to NSW fair trading. Various law restrictions in different states for handling the electrical work are:Ī person installing, touching, repairing, modifying, connecting or disconnecting wires must possess a valid electrical license. Performing electrical work, including wiring, is against the law in every state of Australia since lacking knowledge and skills pose a greater risk of electrical hazard. Source: Source: Source: Source: Source: Source: Source: Source: laws restrict people from wiring the house lights unless qualified or a licensed electrician.

With the right tools, a wiring diagram, and a bit of patience, you can have your double light switch wired up in no time. Wiring a double light switch may seem intimidating at first, but it’s a straightforward project that anyone with basic DIY skills can tackle. If the lights don’t work, double check your wiring and make sure all of the connections are secure. If the lights turn on and off correctly, the double light switch has been successfully wired. Turn the power back on at the circuit breaker and flip the switch. Once the wiring is complete, you’ll need to test the switch. Once the wires are connected, secure the switch to the wall with the screws and use electrical tape to insulate the wiring. Use the wire stripper to strip the ends of the wires and attach them to the new switch, making sure to follow the wiring diagram. Then, remove the existing switch and disconnect the wires.

Start by turning off the power at the circuit breaker. Once you’ve got all the necessary tools and materials, you can begin the wiring process. Tools and Materials Neededīefore beginning the wiring process, you’ll need to gather the following materials: With a few tools, a bit of patience, and this handy guide, you can have your double light switch wired and ready to go in no time. It can be a little intimidating at first, but it’s actually quite simple once you know what needs to be done. Installing a double light switch is a common home improvement project.

Double light switch wiring common